Skip to main content

 

 

MAN, CORVUS AND DNV GL STUDY HYBRID POWER GENERATION

Thursday, June 20, 2019 

Speaking at the recent CIMAC conference in Vancouver, Dr Alexander Knafl, MAN Energy Solutions, presented the results of a new study which examines the potential of hybrid power solutions in light of tightening regulations on greenhouse gas (GHG) emissions.

The result of a cooperation between MAN Energy Solutions, Corvus Energy, and DNV GL, HYCAS examines the cost effectiveness of hybrid power solutions in a 1,700 TEU container feeder vessel.

Working towards the ambitious IMO challenge of reducing shipping emissions 50% by 2050, as compared to 2008, MAN Energy Solutions, Corvus Energy and DNV GL studied the potential of using batteries in a container feeder vessel, to assess if it is possible to both reduce emissions and save operational costs.

“There were several factors that went into the selection of a container feeder vessel for the study,” said Hans Anton Tvete, DNV GL. “We were looking at where hybrid systems could offer significant efficiency gains, which pointed to operational states with fluctuating power demand. This typically occurs with large consumers such as cranes, pumps, ventilation fans, or manoeuvring equipment, especially in port. Container feeders, with their frequent port stays and increased time in port, are ripe for efficiency gains through the use of hybrid solutions. Also, as this fleet is aging, new tonnage is likely to be on order in the near future.”

“Focusing on a container feeder vessel we were able to generate a typical propulsion power profile from vessel speed data, as well as an artificial time-resolved electrical load profile from the according electrical load table. These are the most important inputs for the MAN simulation tool ECO-ESS. Together with the specific battery and engine characteristics, it is possible to optimize the size of a battery in a hybrid propulsion system for the 2020 and 2030 scenario as an optimum of additional CAPEX and OPEX savings.” said Carina Kern, MAN Energy Solutions.

The study explored two main scenarios, a vessel built in 2020 with a 500kWh battery system replacing one genset used for peak shaving and as a spinning reserve, and a vessel built in 2030, using a much larger 11MWh hybrid system for zero emission port entry and exit. Under the first scenario, with the hybrid power train resulting in an approximately 13% total cost for the vessel, payback times are as low as two to three years. However, the larger system increases the costs of the vessel significantly, meaning that only with a combination of lower prices for the battery system and higher fuel costs than today would the system be economically attractive.

“It is our hope that these study results will increase cargo shipowner confidence in seeking out new energy solutions, as a good economic rationale already exists for supporting auxiliary loads with a hybrid configuration,” said Sean Puchalski, Corvus Energy.

“Energy storage has proven to be a highly successful way to reduce emissions for several categories of ships,” said Tommy Sletten, Corvus Energy. “If we speed up the adoption of green technology for vessels transporting goods, then we will really get results. Container vessels are often ‘low cost’ vessels and there is a reluctance to invest in green technology without other initiatives in place. To reach the global goal of 50% carbon emission reduction by 2050, strict regulations and various governmental initiatives are required. Initiatives such as funding for new buildings, slot priority in harbours and reduced port fees for vessels with improved environmental systems will help greatly.”

Reader Comments (0)

There are currently no comments on this article. Why not be the first and leave your thoughts below.

Leave Your Comment

Please keep your comment on topic, any inappropriate comments may be removed.

Return to index

Web Analytics